Publicité
INSTALLATION INSTRUCTIONS
•
For the most secure installation, use a stud-finder to
secure the anti-tip brackets in wall studs. If no studs are
present at the correct installation location, follow the
instructions below.
WARNING
Always make sure that the area to be
drilled into is free of any waterlines or
electrical circuits, which could cause
damage, injury, or death.
•
Use a drill to create holes for wall anchors (#2) at the
marked points 7.9 mm (5/16" Ø), 8 mm).
A. Ø8 mm (5/16")
B. > 62 mm
30
•
Use a hammer to install the wall anchors (#2) if no stud
is present.
•
Install the brackets (#1) in place, using 4 screws for
each.
Fig. 25
Fig. 26
Publicité
