Explanation Display Functions; Explanation Of Buttons - Tunturi Star Fit R100 Manuel De L'utilisateur

Do not lean on the console.
•
Only touch the display with the tip of your finger.
•
Make sure that your nails or sharp objects do not
touch the display.
NOTE
• The console switches to standby mode when the
equipment is not used for 4 minutes.

Explanation Display functions

Time
- Without setting the target value, time will count up.
- When setting the target value, time will count down
from your target time to 0 and alarm will sound or
flash.
- Range 0:00~99:59
Count
-
Displays the number of strokes for the active
workout.
RPM
- Displays the Rotation Per Minute.
Display range 0~20~999.
- Without any signal being transmitted into the
monitor for 3 seconds during workout, RPM will
display "0"
Distance
- Without setting the target value, distance will count
up.
- When setting the target value, distance will count
down from your target distance to 0 with an alarm
sound or flash.
- Range 0.00~99.99
Odo
- Automatically accumulates the Total distance for all
exercise sessions.
- Range: 0.0 ~ 99.99 KM/ 0.00 ~ 9999 KM.
Calories
- Without setting the target value, calorie will count
up.
- When setting the target value, calories will count
down from your target calorie to 0 with an alarm
sound or flash.
- Range 0~999.9.
NOTE
This data is a rough guide for comparison of
•
different exercise sessions which cannot be used
in medical treatment
Watt
- Display current workout watts.
- Range: 0.0 ~ 999.9 Watt.
Target HR
- Display user Target Heart rate
(in workout mode only)
Based on 70% of max. HR (220-Age)
Age
- Display user age (in programming mode only)
- Range: 10 ~ 99
Pulse
- Current pulse will display after 6 seconds when
detected by the console.
- Without any pulse signal for 6 seconds, console will
display "P".
-
Pulse alarm will sound when current pulse is over
the target pulse.
- Range 0-60 ~ 220 BPM.
Level
- Shows tension level setting.
- Range: 1 ~ 24
Program
- Show current selected workout mode. (1 ~ 19)

Explanation of buttons

Arrow up
-
Increase resistance level in workout mode
- Setting selection in programming mode.
Arrow down
- Decrease resistance level in workout mode.
- Setting selection in programming mode.
Mode
-
Press MODE button to switch between the
parameters of the multi display windows.
(in workout mode)
Enter
- Confirm setting or selection.
Start/ Stop
- Start or Stop workout.
- Push and hold "Start/ Stop" button for 3 seconds
to reset: Time, Speed, Distance, Calories, Pulse &
Program.
Recovery
- After the console detects pulse signal, press the
RECOVERY key to enter recovery mode to monitor
heart rate recovery ability
1 7
English