Publicité
Programmable hidden functions list
Self level: with pump - no pump (▲ ▼ UP/
DOWN to switch).
Self level sense: 1 - 2 - 3 (▲ ▼ UP/DOWN to
switch)
Hot water: with pump - no pump
(▲ ▼ UP/DOWN to switch).
Level in delivery: not active - active
(▲ ▼ UP/DOWN to switch).
Temperature calibration: -15 - 0 - 15 °C/F
(▲ ▼ UP/DOWN to switch).
Pressure calibration: -200 - 0 - 200 mbar
(▲ ▼ UP/DOWN to switch).
Pre brewing: not active - active (▲ ▼ UP/
DOWN to switch).
Cup warmer: single - single temp. - double
temp (▲ ▼ UP/DOWN to switch).
Clock calibration: -300 - 0 - 300 sec/month
(▲ ▼ UP/DOWN to switch).
Serial connection: active - not active
(▲ ▼ UP/DOWN p to switch).
Least group: 0 - 1 - 2 - 3 (▲ ▼ UP/DOWN to
switch).
Least serve: 0 - 1 - 2 - 3 (▲ ▼ UP/DOWN to
switch).
DIRECT LINKS
In "machine ready" state you can go direct to
the settings below instead of surfing the menu.
SETTING THE TEMPERATURE POINT:
Press ENTER + ▲ to go directly to the Setting
Point menu (this will be bars or °C/°F depend
on the status view you were).
▲ ▼ press UP or DOWN to move up and
down the working Point.
Press ENTER to confirm and pass to the next
step.
MONITORING UNIT (°C/°F - BAR):
The display can also show you the pressure or
temperature status of the boiler; to pass from
one to the other, press the ▼ key on the dis-
play.
In the case of pressure, the reading will be shown
in bar, while for temperature, it will be in degrees
Celsius (°C) or Fahrenheit (°F). The display set-
ting for the temperature can be chosen from the
setpoint setting page. In fact, when choosing the
temperature mode, the setpoint will be shown in
degrees Celsius or Fahrenheit according to the
chosen measurement.
ON OFF STAND-BY
(ENERGY SAVING MODE)
This allows to rotate into the three working
modes/statuses.
Press RESET for 3 sec to switch on
stand-by the machine status.
off
59
Publicité
