Publicité
DELIVERY COUNT:
• The display will read:
DELIVERY COUNT
• By pressing the ENTER key the display will
read:
SELECTION
TOTAL SELECT
• ll the delivery keys will start to flash on and off.
By pressing one of the delivery keys the amount
of the deliveries made will be visualised.
• Hold down the RESET key for 3 seconds to
reset.
NOTE: The continuous coffee equals one deliv-
ery.
• Press ▼key and the display will read:
MACHINE TOTAL
DELIVE. XXXX
This indicates the total amount of deliveries
made.
• Hold down the RESET key for 3 seconds to
reset.
• By pressing the ▼ key the display will read:
CLEANING COUNTER
To access the automatic cleaning counter
press ENTER.
• The long coffee keys
, on the machine
will begin to flash; when the group key is
pressed, the display will show the number of
wash cycles carried out. Hold down the
RESET key for 3 seconds to reset.
ACTIVE UNITS (T3 VERSION ONLY):
• It is possible to set both the units actually
present and those to be enabled when the
control unit is switched on. To set the number
of active units when the machine is switched
on and to change the active units, proceed
as follows:
• Switch on the function by pressing the
ENTER key.
• It is possible to activate/deactivate individual
units by pressing the ▲ ▼ keys. Press
ENTER to confirm and to pass on to the next
unit. When the last unit is confirmed, the
function returns to the main menu.
• Pressing the RESET key returns to the main
menu and any changes made will not be
saved.
NOTE: To make a change effective, it is neces-
sary to switch the machine off and then
on again, using the main switch located
in the bottom right.
NOTE: From the machine ready state, it is pos-
sible to activate/deactivate the deacti-
vated/activated units by pressing the ▲
key and the button for the unit in ques-
tion. This temporary change is active
until the machine is switched off and
then on again from the main switch.
NOTE: f the electronic control unit is replaced,
when the "ACTIVE UNITS" are shown
on the display, it is necessary to press
the
long coffee key for the first and
second group to make sure that in the
"ACTIVE GROUPS X" on the display, X
actually corresponds to the number of
units in-stalled on the machine.
it is possible to change the value with
the keys ▲ ▼.
For machines with 2 units, the value
should be X=2, for machines with 3 units,
the value should be X=3, for machines
with 4 units, the value should be X=4.
PROGRAM. ON/OFF:
• The display will read:
ON-OFF PROGRAM.
• By pressing the ENTER, the display will read:
MONDAY
ON 07:30 OFF 23.30
where the ON and OFF values indicate when
the machine will turn on and off.
• Press ▲ ▼ to change the day forward and
backward.
• Press ENTER to vary the programmed start-
ing up time (the message ON 07:30 will start
to flash on and off).
• Use the ▲ ▼ keys to vary the starting up
time.
• Press ENTER to confirm and to go on to the
programmed switching off time (the mes-
sage OFF 23.30 will start to flash on and off).
• Use the ▲ ▼ keys to vary the switching off
time.
• Confirm by pressing ENTER.
53
Publicité
