Publicité
TRANSPORT AND HANDLING
APPLIANCE
IDENTIFICATION
When contacting the manufacturer, Simonelli
Group for any reason, always quote the machine
serial number.
The machine is transported on pallets contain-
ing several machines inside boxes secured to
the pallet by straps.
Before performing any transport or handling
operation, the operator must:
•
wear safety gloves and footwear and over-
alls with elasticised ends.
Pallets must be transported using an adequate
lifting mechanism (fork-lift truck type).
CAUTION:
COLLISION OR CRUSHING HAZARD
During the entire handling operation,
the operator must make sure no one or
nothing is inside the operating area.
Slowly lift the pallet to about 30 cm from
the ground and move to the loading
area. After making sure there are no
obstacles, persons or things, proceed
with loading. Once at destination,
always using an adequate lifting mecha-
nism (eg. fork-lift), after making sure
there is no one or nothing within the
unloading area, lower the pallet to about
30 cm from the ground and transport it
to the storage area.
36
CAUTION:
COLLISION OR CRUSHING HAZARD
Before performing the following opera-
tion, make sure the load is in place and
is not likely to fall when the straps are
cut.
The operator, wearing safety gloves and
footwear, must now cut the straps and
store the product. To perform this oper-
ation, check the technical characteris-
tics of the product to determine the
weight of the machine to be stored and
take consequent precautions.
POLLUTION HAZARD
Once the machine has been freed of the
pallet or container, do not discard these
in the environment - pollution hazard.
Publicité
