Publicité
6
Commissioning
6.1
Setting
Error output during the teach-in
6.2
Function configuration
8015556/1PJO/2024-10-07 | SICK
Subject to change without notice
Manual adjustment
Press one of the selection buttons: The switching threshold indicator flashes. Adjust‐
ment is now possible. Adjust using the selection buttons.
1 Normal
↓
3 0 0 3 5 0
An error message is output if the input is faulty during the configuration. See the table
below.
Table 1: Error output during the teach-in
LED/fault pattern
Err1
Err2
Err3
Notes on function configuration
•
Press the configuration button for approx. 0.3 s if not specified otherwise.
•
The display flashes when the setting selection is available.
Function configuration
Press the Mode button for 3 s.
1. Operating mode configuration
Table 2: Operating mode configuration
1. Betriebseinstellung
L — — d L o n
TOP
OPERATING INSTRUCTIONS
Automatically reverts to the normal dis‐
play 5 s after completing the adjust‐
ment.
Cause
Received value is too low.
Received value is too low
Difference between two received values is too
small
To select the operating mode.
Select
and adjust
. The display reverts to the
Operating mode configuration top menu.
ON bright switching
L o n
ON dark switching
d o n
1)
Factory setting
Choose the time configuration 1x Out or 2x Out
O P E R A T I N G I N S T R U C T I O N S | WLL180T-x632, WLL180T-x634
en
1)
37
Publicité
