Publicité
en | us-ca
Compliance with the radio regulations in North America has been verified in accordance with FCC Part 15 subpart B and
C, RSS-GEN, RSS-247 and FCC §15.247. Operation is subject to the following two conditions:
This device may not cause harmful interference.
1.
2.
This device must accept any interference received, including interference that may cause undesired operation.
NOTE! This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part
15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential
installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause
harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the
user is encouraged to try to correct the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
CAUTION TO THE USER: Changes or modification not expressly approved by the party responsible for compliance could
void the user s authority to operate the equipment.
Maintenance
Always disconnect the power before maintenance!
Only use original Mirka spare parts!
Replacing the backing pad and interface
Tools required: Hex socket 19 mm, Torx T8 screwdriver and flat head screwdriver.
Remove hole screws (8 pcs).
1.
Remove the interface.
2.
3.
Remove the cover cap. Untighten the screw to remove the backing pad.
4.
Remove the screw.
Remove the old pad.
5.
Attach the new backing pad to the spindle (aligned correctly) and tighten the pad screw with the hex socket.
6.
7.
Attach the cover cap.
8.
Fit a new interface.
Refit hole screws (8 pcs).
9.
Replacing the brake seal
Remove the backing pad as described above.
1.
Pull the old brake seal out of its groove.
2.
3.
Fit the new brake seal in the groove.
4.
Fit the backing pad as described above.
Further service
Servicing must always be performed by trained personnel. To keep the tool warranty valid and ensure optimal tool safety
and function, servicing must be carried out by a Mirka authorized service centre. To locate your local Mirka authorized
service centre, contact Mirka Customer Service, your Mirka dealer or go to www.mirka.com
44
Mirka® LEROS(-S) 950X
Publicité
