Publicité
Use the power tool, accessories and tool bits etc. in accordance with these instructions, taking into
g.
account the working conditions and the work to be performed. Use of the power tool for operations
different from those intended could result in a hazardous situation.
h.
Keep handles and grasping surfaces dry, clean and free from oil and grease. Slippery handles and
grasping surfaces do not allow for safe handling and control of the tool in unexpected situations.
5.
Service
Have your power tool serviced by a qualified repair person using only identical replacement parts.
a.
This will ensure that the safety of the power tool is maintained.
Additional Safety Warnings
• The safety of the tool is granted only by using original Mirka backing pads.
• Read the Materials Safety Data Sheet (MSDS) for the work surface.
• If any physical hand/wrist discomfort is experienced, stop working and seek medical attention. Hand, wrist and arm
injury may result from repetitive work, motion and overexposure to vibrations.
• Always refit the cover cap after installing the backing pad.
• The power supply socket and connector are non-IEC appliance couplers. Only use an original Mirka power supply cable.
The Mirka power supply cable can be bought from your Mirka Dealer.
• Check the tool, backing pad, power cord and fittings regularly for wear. If the power supply cable is damaged it must
be replaced by an original Mirka power supply cable.
• Clean or replace the dust extractor´s collection bag daily. Dust can be highly combustible. Cleaning or replacing the
bag also assures optimum performance.
• If the tool appears to malfunction, stop using it immediately and arrange for service and repair.
• Keep hands clear of the spinning accessory during use.
• Do not allow the tool to free speed without taking precautions to protect surrounding people and objects in the event
that the abrasive or backing pad should come loose.
• Do not use in wet conditions.
Additional Warnings
Some dust created by power sanding, sawing, grinding, drilling, and other construction activities contains chemicals
known to cause cancer, birth defects or other reproductive harm. Some examples of these chemicals are:
• lead from lead-based paints,
• crystalline silica from bricks and cement and other masonry products, and
• arsenic and chromium from chemicallytreated lumber.
Your risk from these exposures varies, depending on how often you do this type of work. To reduce your exposure to
these chemicals: work in a well ventilated area, and work with approved safety equipment, such as those dust masks that
are specially designed to filter out microscopic particles.
Technical data
LEROS
950X
Power
250 W
Mains voltage
100 240 VAC
Speed
4,000 8,000 rpm
Orbit
5 mm (3/16")
Size of backing pad
Ø 225 mm (9")
Weight
3.5 kg (7.7 lbs)
Degree of protection
I
Noise and vibration information
The measured values may be used for comparing one tool with another and in a preliminary assessment of exposure.
-S 950X
250 W
100 240 VAC
4,000 8,000 rpm
5 mm (3/16")
Ø 225 mm (9")
3.2 kg (7.1 lbs)
I
en (original)
27
Mirka® LEROS(-S) 950X
Publicité
