Publicité
en | us-ca
Technical data
LEROS
Power
Mains voltage
Speed
Orbit
Size of backing pad
Weight
Degree of protection
Noise and vibration information
The measured values may be used for comparing one tool with another and in a preliminary assessment of exposure.
LEROS
Sound pressure level (L
Sound power level (L
Sound measurement uncertainty
K
WA
Vibration emission value a
Vibration emission uncertainty K
*
Specifications subject to change without prior notice. Model range may vary between markets.
*
The values stated in the table are derived from laboratory testing in conformity with stated codes and standards and
are not sufficient for risk evaluation. Values measured in a particular work place may be higher than the declared
values. The actual exposure values and amount of risk or harm experienced by an individual are unique to each situ-
ation and depend upon the surrounding environment, the way the individual operates the machinery, the particular
material being worked, work station design and the user's exposure time and physical condition. Mirka accepts no
responsibility for the consequences of using declared values instead of actual exposure values for any individual risk
assessment.
Further occupational health and safety information can be obtained from the following websites:
https://osha.europa.eu/en (Europe) or http://www.osha.gov (USA)
Proper use of tool
This sander is designed for sanding all types of materials, i.e. metals, wood, stone, plastics, etc. using abrasives designed
for this purpose. Do not use this sander for any other purpose than that specified without consulting the manufacturer
or the manufacturer s authorized supplier. Do not use backing pads that have a working speed of less than 8,000 rpm
free speed. Only use original Mirka backing pads that are designed for optimal performance with the brake seal. Other
backing pads may reduce performance and will increase vibration. The cooling air vents on the housing must be kept
clean and free of blockages to ensure air circulation. Any maintenance or repair work requiring the motor housing to be
opened may only be carried out by an authorized service centre.
Work stations
The tool is intended to be operated as a hand-held tool. It is always recommended that the tool should be used when
standing on a solid floor. It can be in any position but before any such use, the operator must be in a secure position,
having a firm grip and footing and be aware that the tool can develop a torque reaction. See the section "Operating
instructions".
42
Mirka® LEROS(-S) 950X
950X
250 W
100 120 VAC
4,000 8,000 rpm
5 mm (3/16")
Ø 225 mm (9")
3.5 kg (7.7 lbs)
I
950X
)
73 dB(A)
pA
)
84 dB(A)
WA
3.0 dB(A)
*
2
2.5 m/s
h
2
1.5 m/s
PA
-S 950X
250 W
100 120 VAC
4,000 8,000 rpm
5 mm (3/16")
Ø 225 mm (9")
3.2 kg (7.1 lbs)
I
-S 950X
73 dB(A)
84 dB(A)
3.0 dB(A)
2
2.5 m/s
2
1.5 m/s
Publicité
