Scheppach DP16SL Traduction Des Instructions D'origine page 30

h) Keep handles and grasping surfaces dry,
clean and free from oil and grease. Slippery
handles and grasping surfaces do not allow for
safe handling and control of the tool in unexpected
situations.
Service
a) Have your power tool serviced by a qualified
repair person using only identical replacement
parts. This will ensure that the safety of the power
tool is maintained.
Safety instructions for drills
a) The drill must be secured. An incorrectly se-
cured drill can move or topple and this can result
in injuries.
b) The workpiece must be clamped or fastened to the
workpiece support. Do not drill into workpieces that
are too small to be securely clamped. Holding the
workpiece by hand can lead to injuries.
c) Do not wear gloves. Gloves can be caught by rot-
ating parts or drilling debris and thus cause injuries.
d) Keep your hands away from the drilling area whilst
the electrical tool is running. Contact with rotating
parts or drilling debris can cause injuries.
e) The drill must be turning before it makes contact
with the workpiece. Otherwise, the drill bit can catch
in the workpiece and this can result in an unexpec-
ted movement of the workpiece and cause injuries.
f) If the drill becomes jammed, stop pressing dow-
nwards and switch the electrical tool off. Investigate
and rectify the cause of the jamming. Jamming can
result in an unexpected movement of the workpiece
and can result in serious injuries.
g) Avoid long pieces of drill swarf by interrupting the
downward pressure at regular intervals. Sharp me-
tal swarf can become tangled and lead to injuries.
h) Never remove drilling debris from the drilling area
whilst the electrical tool is running. To remove swarf,
move the drill away from the workpiece, switch off
the electrical tool and wait until the drill has come to
a standstill. Use an aid such as a brush or a hook
to remove the swarf. Contact with rotating parts or
drilling debris can cause injuries.
i) The permissible rotational speed for drill bits with
a rated speed must be at least as high as the high-
est speed cited on the electrical tool. Accessories
that rotate faster than permitted can break and fly off
at high speed.
30 | GB
Protect yourself and you environment from acci-
dents using suitable precautionary measures!
• Do not look directly into the laser beam with unpro-
tected eyes.
• Never look into the path of the beam.
• Never point the laser beam towards reflecting sur-
faces and persons or animals. Even a laser beam
with a low output can cause damage to the eyes.
• Caution - methods other than those specified here
can result in dangerous radiation exposure.
• Never open the laser module. Unexpected exposure
to the beam can occur.
• If the mitre saw is not used for an extended period of
time, the batteries should be removed.
• The laser may not be replaced with a different type
of laser.
• Repairs of the laser may only be carried out by the
laser manufacturer or an authorised representative.
Adhere to the correct mains voltage!
Ensure that the mains voltage corresponds to the spec-
ifications on the type plate.
Use an earthed socket!
The device may only be operated using a socket with
properly installed fuse protection.
Workplace safety
Ensure that the machine is stable and secure. If possi-
ble, secure the machine to a floor plate or a workbench.
Protection against electric shock!
Protect the device against moisture. The device must
not be moist nor operated in a moist environment.
Check the device and the mains connection cable
with plug prior to each use. Avoid physical contact with
earthed parts such as pipes, radiators, etc.
Protect against fire or explosion!
There are sparking components inside the device. Do
not use the device in the vicinity of combustible fluids or
gases. There is a risk of fire or explosion if disregarded.
www.scheppach.com
Attention: Laser radiation
Do not look into the beam
Laser class 2