Publicité
4
English
TO OPEN/CLOSE SHIELD
Pull the shield latch tab on lower left side of the shield outward to release
latch system and then raise the shield. To close the shield, push down the
shield until the shield latch tab fully latches into place.
Apply one or two drops of supplied silicone lubricant around the edge trim
and on other moving parts and wipe off with soft tissue paper to maintain
proper operation.
WARNING: If your shield becomes too scratched or uncleanable, replace
it with a new one. Impaired visibility causes accidents. Use a solution of
mild soap or detergent and lukewarm water to clean your shield. Rinse
well with clean water, and wipe off with a soft cloth. Never use petrol,
thinner, benzene or any other solvents. There are many "aggressive"
cleaners on the market, including some supposed to be specifically for
use on shield. Arai strongly recommends that you do not use any such
products to clean your shield as some of their ingredients may have
damaging effects on the shield and other plastic parts installed on your
helmet. Do not apply stickers or adhesive tape to the shield, as this will
weaken the hard coating. If tinted, the shield is for daylight use only.
TO OPERATE BROWVENTS
The Browvents are operated from fully closed through intermediate, to fully
open positions by simply pulling the vent control down to open, pushing
up to close.
Publicité
Chapitres
