Publicité
GENERAL INFORMATION
ENERGY SAVING
For optimal energy saving, we recommend the following:
•
Install the appliance away from heat sources, out of
direct sunlight and in a well-ventilated room.
•
Avoid putting hot food into the refrigerator, which would
raise the internal temperature, thus causing the
compressor to run continuously.
•
Do not overfill the compartments, as this prevents air
from circulating properly.
•
If ice should form, defrost the appliance in order to
facilitate the transfer of cold.
•
In the event of an electrical power failure, it is advisable
to keep the refrigerator door closed.
•
Open the appliance doors as infrequently and for the
briefest amounts of time possible.
•
Do
not
adjust
the
temperatures.
•
Remove any dust that accumulates on the back of the
appliance
BEFORE FIRST USE
You must allow the fridge to settle for at least four
hours prior to switching the power on.
It is recommended that you clean the interior of the
appliance prior to first use using a solution of bicarbonate of
soda and warm water, then thoroughly dry the interior. The
fridge may have an odour to it at first use. This will
disappear as the appliance cools.
NOTE
The appliance will start operating at 41 ℉
for the fridge and 0 ℉ for the freezer and
work continuously until it comes down to
the correct temperatures. If the appliance is
switched off, you should allow five minutes
before switching it on again in order to
prevent
unnecessary
compressor. Never store inflammable or
explosive items, strong corrosive acids or
alkalis in the appliance. This fridge cools
your food by making the inside back of the
cavity cold. It is normal for frost to build up
on this surface; it then dissipates and
drains through a small drain at the bottom,
where
it
presence of frost at the back does not
mean that the fridge is malfunctioning.
settings
to
extremely
damage
evaporates
harmlessly.
cold
to
the
The
9
Publicité
