Publicité
CARE AND MAINTENANCE
LED LIGHT REPLACEMENT INSTRUCTIONS
NOTE
The LED light is intended to be non-
replaceable by the user; it needs to be
replaced by a service professional.
Lighting parameters: 12V / 10W
1) Unplug the power plug.
2) Remove the aluminium alloy trim strip on the top of the
LED surface light source, then remove the left and right
mounting screws.
Steps 1 and 2 are shown below.
3) Install the new LED light board.
4) Finally, replace the aluminium alloy trim strip.
1
2
Fig. 5
CARE AND CLEANING
Always disconnect the appliance from the mains power
before performing any cleaning or maintenance.
The fridge and freezer sections should be cleaned using a
solution of bicarbonate of soda and lukewarm water. Do not
use abrasive products or detergents. After washing, rinse
and dry thoroughly.
Clean the shelves and door bins separately by hand with a
mild solution of washing-up liquid and water. Do not put
them in the dishwasher.
If the appliance is not going to be used for an extended
period of time, unplug and clean the appliance. The doors
should be left slightly ajar to prevent the formation of
mildew and unpleasant odours.
DEFROSTING
The product has a No Frost system, which is designed to
prevent heavy build-up of ice. Under normal conditions of
use, there should be no need to regularly defrost the
freezer system.
NOTE
If you are regularly finding a heavy build-up
of ice or puddles of water in the freezer
section, then it is likely that the door is not
sealing properly. This could be due to a
defective door seal or an incorrectly fitted
or overly heavy cabinet door panel. For
more information, see the troubleshooting
section about ice.
15
Publicité
