Publicité
USE
WATER CONNECTION INSTRUCTIONS
The refrigerator is equipped with a 59" long water hose (1/4"
diameter) that includes a female 1/4" compression
fitting nut, provided in the accessory
refrigerator packaging.
Before installation, the refrigerator's water system must be
connected to the house's main water supply . To do this,
connect the water hose to the rear of the refrigerator and
then to your home's water supply.
The refrigerator does not come with a water filter. However,
a third-party water filter can be installed if desired. The
water supply line must be located either inside the cabinet
where the appliance is installed or in an adjacent cabinet,
with an opening at the rear of one of these cabinets.
The refrigerator's water sy stem must be connected to the
house's main water supply.
The pressure of the water system must be between 25-80
psi (1.7-5.5 bar). If the water pressure exceeds 80 psi (5.5
bar) but remains below 120 psi (8 bar), install a pressure
limiting device or water impact protector to the inlet valve.
WARNING
Do not install or operate the appliance if the
water pressure exceeds 120 psi (8 bar).
Objects that might pierce the water hose or
cause them to twist must not be present
where the water line is installed
WARNING
The hose that runs from the water supply
must be one piece. Do not use extension
hoses.
WARNING
Make sure that the power is cut off when
establishing
connection.
WARNING
The water valve must be closed when
connecting the water hose.
WARNING
It is strongly recommended to keep the
water
valve
installation.
WARNING
This appliance is suitable for use with a
cold potable water supply only.
14
bag inside the
the
appliance's
accessible
after
product
NOTE
Once the connection is complete, open the
water valve and make sure that there is no
leakage. Otherwise, water may damage the
cabinetry.
water
Fig. 4
Publicité
