Publicité
INSTALLATION INSTRUCTIONS
MOUNTING THE CABINET DOOR(S)
1) Ensure that there is a gap of 1/8" to 3/16" between the
non-hinged side of the fridge and the cabinet wall.
2) Locate the slider in the bracket and mount the slider on
the cabinet door, 13/16" to 7/8" from the long edge of the
cabinet door, as shown in the following image, ensuring
that the slider is positioned centrally and horizontally
within the bracket. Tighten securely by hand.
•
A 13/16"
3) Fill the gap on the non-hinged side with the gasket/
sealing strip provided.
A
•
A Seal
4) The finished look for the door sliders should be similar to
those shown in the following image, which shows 2
sliders in place.
•
A Cabinet door
A
Fig. 14
Fig. 15
A
Fig. 16
Ensure the appliance doors open, close and seal
properly.
Once complete, and if you are happy with the fit of the
appliance in the cabinet, bend and snap off the parts of the
white spacers marked "S", as shown by the dotted outline.
Leave the remaining portions of the spacer covers in place
over the metal plates.
NOTE
After completing the installation, check that
the appliance is secure within the cabinet
and that the door (s) close and open
properly. If there is no resistance from the
door seals when opening the door(s), then
it is probable that the appliance and/or
cabinet door(s) are not fitted properly.
S
Fig. 17
21
Publicité
