Publicité
GB
Consumers must dispose of waste electrical devices,
spent portable batteries and rechargeable batteries
separately from household waste at an official collec-
tion point to ensure that these items are processed
correctly. The product can be returned free of charge
in accordance with the legal requirements, for exam-
ple through a municipal waste disposal company or a
dealer.
Batteries, rechargeable batteries and lamps
that are not permanently installed in waste
electrical equipment and can be removed in
a non-destructive way must be removed and
disposed of separately before disposal of the equip-
ment. Lithium batteries and rechargeable battery
packs of all systems are only to be handed in to the
waste collection points in a discharged state. The bat-
teries must always be protected against short circuits
by taping off the poles.
All end users are responsible for deleting any per-
sonal data stored on waste devices prior to their dis-
posal.
Disposing of the packaging
The packaging consists of cardboard and
marked plastics that can be recycled.
– Take these materials to a recycling cen-
tre.
Error/Fault
Awning does not extend or retract
(neither with the radio remote con-
trol nor via the switch).
Motor does not stop after the awning
has been extended or retracted.
The motor will stop once the awning
has been fully extended or retract-
ed.
Awning fabric is rolling up unevenly. Fabric tilt is not set correctly?
Awning does not retract fully on one
side.
Does the awning fabric rub against
the fixing screw of the middle wall
bracket?
The remote control is not respond-
ing to extend/retract commands.
Despite having performed program-
ming, button (12) does not respond.
34
Troubleshooting
What to do when something doesn't work...
Malfunctions are often caused by minor faults. You
can easily remedy most of these yourself. Please
consult the following table before contacting the ven-
dor. You will save yourself a lot of trouble and possibly
money too.
Cause
Power feed has been interrupted?
Motor/switch connected incorrectly? Check the connections to motor/
Switch defective?
Is the motor defective?
End position switch is not set cor-
rectly?
End position switch is not set cor-
rectly?
Cloth distorted?
Are the wall brackets not attached in
a perfectly horizontal position?
Remote control has not been
taught?
Programming failed?
DANGER! Risk of injury! Contact your
local vendor.
NOTICE! Potential damage to the awn-
ing fabric! After multiple uses of the awn-
ing, one or both of the hinged arms may
hang at the wrong angle or unevenly. If
this happens, the hinged arms must be
readjusted (► Adjusting the angle of tilt of
the awning fabric – p. 32).
Note: To ensure trouble-free operation of
the awning, the hinged joints of the hinged
arms should be lubricated at regular inter-
vals using a resin-free and acid-free oil.
Remedy
Check the power source.
switch.
Contact your local vendor.
Contact your local vendor.
Setting the end position switch.
Setting the end position switch.
Adjusting the canopy angle.
Line the shaft with awning material:
Completely extend the awning and
place a piece of fabric on the side
that will not close all the way, right
where the cloth begins. Then care-
fully retract the awning again, so
that the fabric retracts together with
the awning cloth. That will cause the
cloth to move back further with
every rotation and the awning can
completely close.
Mount the wall brackets horizontally.
Program the remote control.
Press button (12) on the remote
control. Insert the setting tool into
the setting screw (B) and rotate in
the + direction until the motor starts
to operate.
Publicité
