Emptying The Container (Version H-) - Nilfisk Advance IV 022 Mode D'emploi

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

INSTRUCTIONS FOR USE
EMPTYING THE CONTAINER
(VERSION H-)
Before emptying, switch off the motor. Shake the filter a
number of times and give the dust time to settle.
Release the container using the lever.
Switch the motor back on and follow these steps:
– remove the container from below the machine;
– close the container "1" lid;
– remove the sealed container "2";
– insert a new empty container into the dust container
and refit it into the vacuum cleaner.
Carefully check that the waste container (when mounted)
is perfectly tight with the filtering chamber. The elimination
of the container containing toxic substances must be done
following the existing rules.
Using a Dust Safe Bag system, Dust class H.
Fitting the Dust safe Bag
Place the special dust bag flat in the bin with its opening
pointing towards the bin inlet.
Now slide the opening in the special dust bag on to the bin
inlet as far as it will go – without any turning.
Then fold the plastic bag down over the bin rim.
Now pull the part of the plastic bag overlapping the bin rim
tight against the flange (before re-attaching the top and
bottom sections of the vacuum cleaner).
10
Once the dust bag is full
Leave the hose connected or close to the lid!
After opening the appliance detach the plastic bag lying
across the bin rim carefully, close and seal it.
Detach the back of the connecting flange by briefly
pressing firmly downwards at an angle, while holding the
front firmly on the connection piece.
The plastic-hose joint is now visible and can be tied off
securely with the cable tie simply by pulling it together.
Having thus ensured that no dust can escape, now also
detach the front part of the flange from the connection
piece.
Using a Dust Bag system (plastic bag insert) (Fig. 9).
Having opened the system, remove the plastic bag's edge
carefully from the container's rim. Close the bag's opening
and take it out of the container.
Put a new bag into the container. Take care that it fits the
bottom and the walls. Pull the bag's edge over the
container's rim and smooth it down.
Dust Class "L"
Machines of this category of application can be used
without a dust bag. In this case please make sure that the
removal of the dust takes place in a special area and use
a respiratory protection mask.
32401105(1)2004-04 A

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

Advance iv 040

Table des Matières