Using The Vacuum:starting And Stopping; Using The Vacuum/ Cleaning The Main Filter; Using The Vacuum/ Emptying The Container - Nilfisk cfm A15EXP Manuel D'instructions

USING THE VACUUM:STARTING AND STOPPING

1.Fit the accessories on suction inlet "A".
2.Connect the machine to the air main.
3.Start and stop the Vacuum Cleaner by turning the lock valves "B".
4.The pressure governor "C" is used to regulate the suction capacity
CLEANING THE MAIN FILTER
If the performance of the vacuum cleaner decreases during
use, it may be necessary to clean the primary filter:
1. Turn off the vacuum and disconnect the vacuum from
its power source.
2. Actuate the filter shaker "A" (Figure 2) by raising
and lowering the lever.
3. Repeat this several times to shake the dirt from the
primary filter.
4. Wait a few minutes for the dust to settle at the bottom
of the container.
5. Empty the container
EMPTYING THE CONTAINER
1. Turn off the vacuum and disconnect the
vacuum from its power source.
2. Detach container "A" (Figure 3) by lifting
the handle.
3. Slide the container out from the machine
and carry the container by the handle (figure 4).
INSTRUCTIONS FOR USE
3
2
PAGE 5
C
B
4