Publicité
Table of contents
1 Introduction
1.1 Product description ..............................................5
1.2 Intended use ............................................................5
1.3 Symbols ......................................................................5
1.4 Product overview...................................................6
2 Safety
2.1 Safety definitions ...................................................6
2.2 Safety instructions for operation ...................6
2.3 Work area safety ....................................................6
2.4 Electrical safety ......................................................6
2.5 Personal safety .......................................................6
2.6 Power tool use and care ....................................7
2.7 Battery tool use and care ..................................7
2.8 Service ........................................................................8
2.9 Specific safety instructions for mitre saw .8
3 Installation
3.1 To install the product ...........................................9
4 Operation
4.1 To do before you operate the product ........9
4.2 To do a check of the blade guard ..................9
4.3 To attach and change the saw blade ...........9
4.4 To install the workpiece rests ..........................9
4.5 To install the tension clamps ...........................9
4.6 To clamp the workpiece .....................................9
4.7 To install the dust collection bag .................10
4.8 To set the table......................................................10
4.9 To make cuts without a mitre angle ...........10
4.10 To make mitre and bevel cuts .......................10
5 Storage
6 Transportation
6.1 To install and remove the lock pin for
transportation .........................................................11
7 Maintenance
7.1 To clean the product ...........................................11
8 Troubleshooting
9 Disposal
9.1 To discard the product ......................................12
10 Technical data
4
1
Introduction
1.1
Product description
5
The product is a mitre saw with a brushless motor, dust
extraction and collector.
Note! Battery and battery charger are sold separately.
1.2
Intended use
6
The product is used to cut wood, similiar materials and
plastics. The product must be used in dry indoor
environments.
1.3
Symbols
9
9
10
11
11
11
12
12
Read the operating instructions carefully
and make sure that you understand the
instructions before you use the product.
Save the instructions for future reference.
Only intended for indoor use.
Double insulation (safety class II), does not
need to be earthed.
Fuse must be replaced with rating specified
on the product label.
Wear ear protection.
Wear eye protection.
Wear breathing mask.
This product complies with applicable EU
directives and regulations.
Recycle as electrical waste.
Publicité
