Publicité
9
When the cut is completed, release the trigger. Let
the saw blade come to a complete stop and then
move it back to the start position.
5
Storage
Warning! The product must be stopped and the
battery removed before the product is stored.
● Clean the product before it is stored. Refer to "7.1 To clean
the product" on page 10.
● Store the product in a dark, dry, frost-free and
well-ventilated area.
● Store the product out of the reach of children.
● Store the product in its original package.
6
Transportation
Warning! The product must be stopped and the
battery removed before the product is transported.
● Make sure that the lock pin for transport is in place
before the product is transported.
● Only carry the product in the carry handle.
● Protect the product from heavy impact and strong
vibrations when it is transported in a vehicle.
● When transported, secure the product to prevent it to slip
or fall.
6.1
To install and remove the lock pin
for transportation
1
Push the handle and put the transport pin into the
product.
2
To remove the transport pin, push the handle and pull
out the transport pin as far as possible.
8
Troubleshooting
Warning! Any inspection, maintenance and repair work that is not described in the manual must be done by an autho-
rized service center. If the product does not operate correctly after the checks below are done, refer to an authorized service
center.
Problem
The product does not start.
10
Possible cause
The battery is discharged..
There is no battery is installed to the product.
The trigger is defective.
The motor is defective.
7
Maintenance
Warning! The product must be stopped and the
battery removed before any work or maintenance is done to
the product.
Warning! Only accessories and additional equipment
adapted for the product must be used. Other accessories
and additional equipment can cause a risk of injury.
● Any other repair and service work than described in the
manual must be done by an authorized service center.
● The product must be kept clean, dry and free from oil and
grease
7.1
To clean the product
Caution! Make sure that no liquids get into the
product.
● Clean the housing of the product with a damp cloth after
each use.
● Remove dust and chips from the chip ejector after each
use. If needed use compressed air to clean the chip
ejector.
● Do not use petrol, solvents or detergents that can
damage the plastic parts of the product.
Recharge the battery.
Install a battery.
Refer to an authorized service center.
Action
Publicité
