Helios MiniVent M1/100 Notice De Montage Et D'utilisation page 22

Installation and Operation Instructions
EN
CHAPTER 6
INSTALLATION
m
DANGER
m
WARNING
MiniVent M1/100/120
m Danger to life due to electric shock!
All work on/in the unit may only be carried out by qualified personnel in accordance with chapter
„2�1 Personnel qualification" on page 3�
6�1 Scope of delivery/Design
MiniVent M1/100/120..
ä
ù
ò
Leave the delivery unit in its box until installation. Check that the fan is in good condition and has not
been damaged in transit.
6�2 Preparation for wall or ceiling installation (surface mounted)
m The safety instructions in chapter 1�3 must be observed!
The fan is delivered as a complete unit, i.e. ready for connection, as standard. The installation and
start-up of the fan should take place after the completion of all other works and after the final cleaning,
in order to prevent damage and contamination of the ventilation unit.
After the removal of packaging and the start of installation, the following points must be checked:
– is there any transport damage,
– broken or bent parts
– freewheeling of the impeller
6�3 Installation
The M1/100/120 MiniVent is designed for direct wall installation. The housing must not be deformed
or warped during installation, and the flat structure of the installation surface must be ensured. The
fans must only be installed on sufficiently solid and stable subsurfaces with suitable fastening materials.
Sufficient backflow must be ensured! If applicable, observe instructions in DIN 1946-6.
1� Cable exit from the wall:
– The location of the cable outlet varies in the dark area (fig.6).
– Distance to the duct centre depending on cable exit 58/68* mm with a variable position under the
casing.
Fig�5
ò
Facia
ü
ù Terminal compartment cover
incl. 2x fastening screws
ä
Control board
ë Plastic casing with impeller
ö
ö Guide vane removable at reduced installation depth
Å
ü Back draught shutter removable
ë
Å
Cable grommet
î
Assembly kit
î
2x screws including plugs for wall mounting
6