Publicité
2.Slacken the positioning screw.
3.Set distance "X" between the tip of the accessory tool and the tip of the depth gauge.
4.Tighten the positioning screw.
Using parallel guide
CAUTION
Risk of injury and damage due to accessory tool. If parallel guide and accessory tool come into
contact, damage to the parallel guide and/or the accessory tool can result.
▶
Always set the parallel guide to a position where it cannot come into contact with the accessory
tool.
The parallel guide can be used as a cutting guide or as a depth gauge.
Using parallel guide as cutting guide
Use the parallel guide to make straight cuts paralleling an edge.
If applicable, make sure that clamps do not obstruct the free movement of the multitool.
WARNING
Risk of injury and damage due to kickback. If a corner of the accessory tool comes out below or
above the workpiece, kickback occurs and can lead to loss of control.
▶
Make sure the accessory tool remains fully plunged in the workpiece over the entire stroke
(oscillation).
▶
Install the securing collar and the parallel guide.
▶
Make sure that the parallel guide is parallel with the accessory tool.
▶
Slacken the clamping screw of the securing collar.
▶
Turn the securing collar so that the accessory tool will plunge into the workpiece at an angle.
▶
Retighten the clamping screw.
▶
Open the positioning screw.
▶
Set a cutting depth at which the accessory tool remains fully plunged in the workpiece over the
entire oscillating stroke.
▶
Tighten the positioning screw.
▶
Position the multitool with the parallel guide on the edge. Guide the multitool along the edge for
the full length of the cut.
Using parallel guide as depth gauge
Use the parallel guide as a depth gauge when you are working with segment saw blades.
▶
Install the securing collar and the parallel guide.
▶
Slacken the positioning screw.
▶
Set distance "X" between the parallel guide and the tips of the teeth of the segment saw blade.
▶
Tighten the positioning screw.
Care and maintenance
WARNING
Risk of injury with battery inserted !
▶
Always remove the battery before carrying out care and maintenance tasks!
Care of the product
• Carefully remove stubborn dirt.
• Carefully clean the air vents, if present, with a dry, soft brush.
• Use only a slightly damp cloth to clean the housing. Do not use cleaning agents containing silicone
as these can attack the plastic parts.
• Use a dry, clean cloth to clean the contacts of the product.
Care of the Liion batteries
• Never use a battery with clogged air vents. Clean the air vents carefully using a dry, soft brush.
*2381015*
6
2381015
24
24
28
Publicité
