Publicité
Status
One (1) LED shows yellow
One (1) LED quick-flashes red
Indicators showing the battery's state of health
To check the battery's state of health, press the release button and hold it down for longer than
three seconds. The system does not detect a potential malfunction of the battery due to misuse, for
example battery dropped or pierced, external heat damage, etc.
Status
All LEDs show in sequence, followed by one (1)
LED showing constantly green.
All LEDs show in sequence, followed by one (1)
LED quick-flashing yellow.
All LEDs show in sequence, followed by one (1)
LED showing constantly red.
Technical data
Weight in accordance with EPTA-Procedure 01, with-
out battery
Tool holder
No-load oscillation frequency (oscillations per min-
ute), n
0
Arc of oscillation left/right
Ambient temperature for operation
Storage temperature
Battery
Battery operating voltage
Weight, battery
Ambient temperature for operation
Storage temperature
Battery charging starting temperature
Noise information and vibration values in accordance with EN 62841
The sound pressure and vibration values given in these instructions were measured in accordance
with a standardized test and can be used to compare one power tool with another. They can also be
used for a preliminary assessment of exposure.
The data given represent the main applications of the power tool. However, if the power tool is used
for different applications, with different accessory tools, or is poorly maintained, the data can vary.
This can significantly increase exposure over the total working period.
23
Meaning
The Li-ion battery and the product in which it
is inserted are not compatible. Consult Hilti
Service.
The Li-ion battery is locked and cannot be
used. Consult Hilti Service.
Meaning
The battery can remain in use.
The check to ascertain the battery's state of
health did not complete. Repeat the procedure,
or consult Hilti Service.
If a connected product can still be used, the
remaining battery capacity is below 50 %.
If a connected product can no longer be used,
the battery has reached the end of its useful life
and has to be replaced. Consult Hilti Service.
1.3 kg
STARLOCK MAX
10,000 /min ... 20,000 /min
±2°
−17 ℃ ... 60 ℃
−20 ℃ ... 70 ℃
21.6 V
See the end of these operating in-
structions
−17 ℃ ... 60 ℃
−20 ℃ ... 40 ℃
−10 ℃ ... 45 ℃
2381015
*2381015*
Publicité
