Hilti SMT 6-22 Mode D'emploi page 29

An accurate estimation of exposure should also take into account the times when the tool is switched
off, or when it is running but not actually being used for a job. This can significantly reduce exposure
over the total working period.
Identify additional safety measures to protect the operator from the effects of noise and/or vibration,
for example: maintaining the power tool and accessory tools, keeping the hands warm, organization
of work patterns.
Noise information
Sound power level (L
Uncertainty for the sound power level (K
Emission sound pressure level (L
Uncertainty for the sound pressure level (K
Total vibration
Vibration emission value for sanding (a
Vibration emission value for sawing ply-
wood (a )
h
Uncertainty (K)
Preparations at the workplace
WARNING
Risk of injury by inadvertent starting!
▶
Before inserting the battery, make sure that the product is switched off.
▶
Remove the battery before making any adjustments to the power tool or before changing
accessories.
Observe the safety instructions and warnings in this documentation and on the product.
Charging the battery
1.Before charging the battery, read the operating instructions for the charger.
2.Make sure that the contacts on the battery and the contacts on the charger are clean and dry.
3.Use an approved charger to charge the battery.
Inserting the battery
WARNING
Risk of injury by short circuit or falling battery!
▶
Before inserting the battery, make sure that the contacts on the battery and the contacts on the
product are free of foreign matter.
▶
Make sure that the battery always engages correctly.
1.Charge the battery fully before using it for the first time.
2.Push the battery into the product until it engages with an audible click.
3.Check that the battery is seated securely.
Removing the battery
1.Press the battery release button.
2.Remove the battery from the product.
Installing securing collar and depth gauge or parallel guide
1.Slacken the clamping screw of the securing collar, using the hex on the depth gauge or the parallel
guide.
2.Align the 4 positioning lugs with the notches in the tool neck and slip the securing collar on to the
tool neck.
*2381015*
)
WA
)
pA
) B 22­55
h
2381015
87 dB(A)
) 3 dB(A)
WA
79 dB(A)
) 3 dB(A)
pA
3.4 m/s²
B 22­255 2.3 m/s²
B 22­55 2.5 m/s²
B 22­255 4.2 m/s²
1.5 m/s²
22
2
24