Publicité
3.Turn the securing collar to the desired position.
4.Tighten the clamping screw.
5.Slacken the positioning screw of the securing collar.
6.Insert the depth gauge or the parallel guide into the securing collar and secure it with the positioning
screw.
Fitting the accessory tool
WARNING
Risk of injury due to unapproved accessory tool. Unsuitable accessory tools can suffer irreparable
damage in operation or lead to loss of control of the product.
▶
Make sure that the accessory tool's permitted oscillation frequency is at least as high as the
maximum oscillation frequency stated on the product.
WARNING
Risk of injury due to incorrect alignment of the accessory tool. When in operation, the accessory
tool can cause severe cut injuries.
▶
Never position the accessory tool facing toward the grip.
CAUTION
Risk of injury by clamping lever snapping back.
▶
When closing the clamping lever, do not allow the clamping lever to snap back in an uncontrolled
manner. Hold the clamping lever firmly and close it with caution.
The STARLOCK MAX tool mount is compatible with STARLOCK PLUS and STARLOCK
accessory tools.
1.Set the accessory tool on a flat surface.
2.Open the clamping lever completely by turning it counter-clockwise past the first detent to the
stop.
▶
The clamping jaws of the tool holder are closed.
3.Align the star-shaped tool mount of the product with its counterpart on the accessory tool and set
the product on the accessory tool.
4.Close the clamping lever completely by turning it clockwise in a controlled manner past the first
detent to the stop.
▶
The clamping jaws of the tool holder open, holding the accessory tool securely engaged.
5.Check that the accessory tool is held securely.
Removing accessory tool
CAUTION
Risk of injury due to accessory tool! The accessory tool might be hot or have sharp edges.
▶
Wear protective gloves when changing the accessory tool.
CAUTION
Risk of injury and damage due to falling accessory tool. The accessory tool can fall off and lead
to injuries and/or damage to accessory tool and underlying material.
▶
Hold the product and the accessory tool above but close to a surface when you remove the
accessory tool.
1.Open the clamping lever by turning it two clicks counter-clockwise.
▶
The accessory tool is released and separates from the tool holder.
2.Close the clamping lever by turning it clockwise.
25
3
2381015
*2381015*
Publicité
