Publicité
16
5. DISPOSAL OF THE DEVICE (ENVIRONMENT)
At the end of the product life cycle, you should not dispose of this product with normal house-
hold waste. Take this product to a collection point for the recycling of electrical and electronic
equipment. The symbol on the product, user's guide and/or box indicates this. Some of the
product materials can be re-used if you take them to a recycling point. By reusing some parts or
raw materials from used products you make an important contribution to the protection of the
environment. Please contact your local authorities in case you need more information on
the collection points in your area. The internal battery should be disposed of with the Parent unit
in an environmentally-friendly manner according to your local regulations.
6. CLEANING
Clean the Baby Monitor with a slightly damp cloth or with an anti-static cloth. Never use cleaning
agents or abrasive solvents.
Cleaning and care
Do not clean any part of the product with thinners or other solvents and chemicals – this may
•
cause permanent damage to the product which is not covered by the warranty.
Keep the Baby Monitor away from hot, humid areas or strong sunlight, and don't let it get
•
wet.
Every effort has been made to ensure high standards of reliability for your Baby Monitor.
•
However, if something does go wrong, please do not try to repair it yourself – contact
Customer Service for assistance.
IMPORTANT
Always switch off and disconnect the power adaptor before cleaning your baby monitor.
7. HELP
Display
No display
Try recharging the battery pack.
•
Reset the Units. Unplug both the Units' electrical power, then plug them back in.
•
Is the Unit switched on?
•
Press and hold the ON/OFF button
•
Is the correct camera selected? Change the camera number, if necessary.
•
Is the video display turned on? Press the VIDEO ON/OFF button
•
When operating using batteries only, the display will go blank after 5 minutes or 15 minutes
•
or 30 minutes to save power (depending on video settings). The Unit is still active and will
give you audio alerts. You can reactivate the screen by pressing any button.
Registration
If the Baby Unit has lost its link with the Parent Unit
If the Baby Unit is too far away it may be going out of range, so move the Baby Unit closer to
•
the Parent Unit.
Reset both the Parent Unit and Baby Unit by disconnecting them from the electrical power.
•
on the Parent Unit for 3 seconds to switch it ON.
to turn it ON.
Publicité
