Heidolph LABOROTA 20 S A Mode D'emploi page 91


T auto is set to 2 – 10 °C (temperature difference from cooling water).
Set

A high Set T auto value results in high-speed distillation, whereas a low value renders a slow
and controlled distillation process.
When reaching the temperature difference (in the condenser) once set with Set
vacuum valve closes; as soon as the temperature drop equals Set
will open once more. A current Set
Display
Pressing the Select key changes display
reading between Act Vapor, Act T auto,

Set T auto and Set
The Act Vapor, Act T auto, Set

Set Vapor will illuminate.
Act T auto shows command temperature in
the condenser for mode T auto, i.e. at point
5 (see page 120), as soon as the
temperature sensor is installed and
connected with #4 plug connector (T auto
temperature sensor) (see page 120).
Act Vapor shows vapor temperature in the
elbow, i.e. point 1 (see page 119) as soon as the temperature sensor is installed and connected
with #3 plug connector (boiling temperature sensor) (see page 119).

For Set T auto you need to select the Set
Next step is entering final pressure; exceeding this value automatically discontinues distillation.
After about 5 seconds, "Endp" appears in display II, at this point select final pressure. Final
pressure selected appears in the display I.

Vapor setting is 0.5°C.
Act T auto LED
 Vapor LED

Vapor.

T auto or
Act Vapor LED
Select key
increase
decrease

T auto LED. Use Set keys as required.
91

T auto, the

Vapor (hysteresis), the valve
T auto LED
E