Publicité
reduce the risk of starting the tool accidentally, which may result in personal injury.
Trouble
Palm router does
not operate.
Palm router does
not turn on: LED
work light blink-
ing.
Palm router oper-
ates intermittently.
Palm router oper-
ates for a short
time or at a de-
creasing rate per
battery charge.
Palm Router is
hard to control.
Palm router runs
slow; rough cuts,
poor cutting per-
formance.
Friction burns on
the workpiece.
Troubleshooting
Disconnect battery pack from tool before assembly, adjustments, trou-
bleshooting or changing accessories. Such preventive safety measures
Cause
No battery inserted/battery
discharged.
Battery and tool temperature
too high/low.
Spindle Lock Lever in Lock
Position.
Battery inserted with switch in
on position.
Battery not fully charged.
Internal error.
Battery not fully charged.
Battery worn.
Incorrect direction of feed.
Dull or damaged router bit.
Palm router is overloaded.
Feeding too slow.
Corrective Action
Insert charged battery.
Allow battery and/or palm router
to reach permitted operating
temperature. See "Specifica-
tions" on page 12.
Turn switch off. Push Spindle
Lock Lever to Unlock Position.
Turn switch on.
Turn switch off. Remove battery.
Insert battery. Turn switch on.
Charge battery.
Return to Bosch service center
for service.
Charge battery.
Replace battery.
Reverse the direction of feed.
See "Feeding the Palm Router"
on page 30.
Replace router bit.
Back off the workpiece to reduce
the load.
Feeding too fast, adjust the
speed of feed or the palm
router's speed setting.
Cut is too large for one pass.
Make multiple progressively
deeper cuts.
Adjust the speed of feed or the
palm router's speed setting.
39
Publicité
