Publicité
Fig. 11
Removing the Palm Router from
the Offset Base
1. Open the Clamping Lever 16 then
reverse steps 1-4 from section "Install-
ing the Palm Router to the Tilt Base" on
page 18.
Installing the Bit to the Offset Base
(Fig. 12)
1. Insert the shank of the router bit into
the Collet 6 on the Offset Base 29 as
far as it will go, then back the shank out
until the cutters are approximately 1/8"
to 1/4" away from the collet nut face
2. Press the Spindle Lock Button 30 on
top of offset spindle
3. Tighten Collet Nut 7 using the Collet
Nut Wrench 52
Note: The collet used on the PR004 is
the same type of self-releasing collet
used on the palm router itself when
used with the Fixed Base 14.
4. Make a trial cut to check the depth and
readjust as necessary. See "Using the
Palm Router with Offset Base (PR004)"
on page 33.
Assembly
55
21
.
.
Fig. 12
Attaching the Offset Base Roller/
Bushing Guide
(Fig. 13)
The offset base roller/bushing guide is re-
quired when edge-forming or trimming with
unpiloted non-bearing bits.
1. Position the Offset Base Roller/Bushing
Guide 54 to the bottom of the Offset
Base 29
the two provided screws
Fig. 13
.
29
52
30
and secure it in place using
.
54
7
29
17
Publicité
