Publicité
Installing Fixed Base Surface
Routing Dust Extraction Hood
(optional accessory)
(Fig. 9)
1. Place the Fixed Base Surface Routing
Dust Extraction Hood 26 over the base
opening so that the pin on the right side
snaps into the hole on the base
2. Secure the hood in place, on the left
side of the base, with the Dust Extrac-
tion Thumb Screw 53
3. Connect the hood to the vacuum using
either a friction fit nozzle or the Bosch
quick click system.
Fig. 9
53
16
Assembly
.
.
26
Offset Base (PR004) and
Accessories
The offset base allows routing extremely
close to vertical surface in front of the
tool; as close as 1/2" when 3/4" bit is used
(Removal of the black offset spindle cover
further reduces distance from 3/4" bit and
vertical surface to 3/8".) The 1-1/16" base
opening makes it possible to use bits that
have cutters as wide 13/16".
Installing the Palm Router to the
Offset Base
(Fig. 10, Fig. 11)
1. Remove the Collet 6 and Collet Nut 7
from motor and install Drive Gear 55
using Collet Nut Wrench 52. See "Re-
placing the Collet" on page 14. Make
sure that Drive Gear 55 is fully tightened
onto the palm router's Spindle 8
2. Install the Palm Router 8 into the Offset
Base 29. See section "Installing the
Palm Router to the Tilt Base" on page
18.
Note: Fine depth adjustment not avail-
able for Offset Base.
3. Insert a screwdriver through the U-
shaped opening in the Subbase 21 to fit
belt over Drive Gear 55
Fig. 10
1
55
.
.
Publicité
