Télécharger Imprimer la page

Bosch GKF18V-25 Consignes D'utilisation/De Sécurité page 26

Publicité

reduce the risk of starting the tool accidentally, which may result in personal injury.
hearing protection used for appropriate conditions will reduce personal injuries.
Setting Depth of Cut
Setting Depth of Cut for Fixed
(GKF001) and Tilt (PR005) Base
(Fig. 28, Fig. 29)
The depth of cut can be adjusted in rough
and fine increments. Rough depth adjust-
ment is possible when the Depth Setting
Indicator 18 is aligned with the Unlock Sym-
bol 12 on the Palm Router 1. Fine depth ad-
justment is possible when the Depth Setting
Indicator 18 is aligned with the Lock Symbol
13 on the Palm Router 1. In order to main-
tain the desired depth setting during appli-
cation, ensure that the Depth Setting Indica-
tor 18 is aligned with the Lock Symbol 13 on
the Palm Router 1 and the Clamping Lever
16 is closed.
1. Install the desired router bit. See "In-
stalling/Removing a Router Bit" on page
13.
2. Place the router/base assembly on the
workpiece.
3. Open the Clamping Lever 16
4. While holding the base in place, rotate
the Palm Router 1 counter-clockwise un-
til the Depth Setting Indicator 18 aligns
with the Unlock Symbol 12
depth adjustment setting).
5. Slowly lower the router until the router-
bit touches the workpiece
6. Note the reading on the Depth Scale
5 and add the desired depth-of cut to
this value to determine the target scale
value.
7. Lift the router/base assembly from the
workpiece and push the Palm Router 1
into the base until the target scale value
is reached.
8. Rotate the base clockwise until it locks
into the Palm Router 1
Setting Indicator 18 will align with the
26
Disconnect battery pack from tool before assembly, adjustments, trou-
bleshooting or changing accessories. Such preventive safety measures
Use personal protective equipment. Always wear eye protection. Protec-
tive equipment such as a dust mask, non-skid safety shoes, hard hat, or
.
(rough
.
; the Depth
Operation
Lock Symbol 13 (fine depth adjustment
setting) on the router.
9. If necessary, use the Microfine Adjust-
ment Wheel 17 to precisely reach the
desired depth on the Depth Scale 5
; each complete rotation of the dial
equals 1.25 mm (approximately 3/64).
10. Close the Clamping Lever 16
Note: The tightness of the clamping
lever can be adjusted as needed. See
"Adjusting the Clamping Lever" on page
25.
11. Ensure that the Palm Router 1 is se-
cured tightly in the base.
12. Make a trial cut to verify that the Palm
Router 1 is set to the desired depth.
Fig. 28
12
16
18
.
1

Publicité

loading

Ce manuel est également adapté pour:

Gkf18v-25n professional