Publicité
Centering a Subbase or Template
Guide with an Opening 1/2" or
Larger
(Fig. 25)
1. Loosen the four Subbase Screws 50
2. Slide the narrow end Centering Pin 46
into the Cone 47
3. Insert the narrow end of the Centering
Pin 46 into Collet 6
Nut 7 with fingers to put slight grip on
Centering Pin 46.
4. Lightly press the Cone 47 into Subbase
21 to center.
5. Tighten the four Subbase Screws 50
6. Remove Centering Pin 46 and Cone 47.
Fig. 25
21
7
24
Assembly
.
. Tighten Collet
46
47
47
50
46
6
Inserting and Removing the
Battery Pack
(Fig. 26)
To Insert the Battery Pack
.
Slide charged Battery Pack 9 onto the Palm
Router 1 until the Battery Pack 9 locks into
position.
Your tool is equipped with a secondary lock-
ing latch to prevent the Battery Pack 9 from
completely falling out of the handle, should
it become loose due to vibration.
To Remove the Battery Pack
.
Press the Battery Pack Release Button 10
and slide the Battery Pack 9 from the Palm
Router 1.
Fig. 26
10
9
1
Publicité
