Publicité
Using the Palm Router with
Plunge Base (PR011) and
Accessories
(Fig. 44)
Using the Palm Router with Plunge
Base
1. Install the router bit. See "Installing/Re-
moving a Router Bit" on page 13.
2. Adjust the cutting depth. See "Setting
Depth of Cut" on page 26.
3. Install the Battery Pack 9.
4. Grip the Plunge Base 34 firmly using
both Plunge Base Grips 35.
5. Adjust the speed. See "Variable Speed
Dial" on page 29.
6. Switch the Palm Router 1 on. See "(Fig.
32)" on page 29.
7. Allow the palm router bit to reach full
speed before plunging the cutter head
into the workpiece.
8. Push down the Plunge Lock Lever 36
and plunge the router down until the
router bit reaches the set depth.
9. Release the Plunge Lock Lever 36.
10. Perform the routing operation. See
"Feeding the Palm Router" on page
30.
Note: the speed may be adjusted while
the palm router is in operation.
11. Once routing is complete, unlock the
Plunge Lock Lever 36 so the router bit
disengages the workpiece.
Fig. 44
35
36
Operation
12. Turn the Palm Router 1 off. See "(Fig.
32)" on page 29.
Deluxe Router Guide (RA1054)
(optional accessory)
(Fig. 45)
The Bosch deluxe router guide is an optional
accessory that will guide the palm router
parallel to a straight edge or allow you to
create circles and arcs.
With the Deluxe Router Guide 42 installed
and adjusted, the router should be fed nor-
mally, keeping the guide in contact with
the edge of the workpiece at all times. See
"Feeding the Palm Router" on page 30.
The deluxe router guide may also be posi-
tioned directly under the router base for op-
erations where a cut is needed close to or at
the edge of the work.
The deluxe router guide includes a dust ex-
traction hood and the VAC002 vacuum hose
adapter.
For complete instructions on installation
and operation, please refer to the instruc-
tions included with this accessory.
Fig. 45
36
35
42
Publicité
