Publicité
Guiding the Palm Router
(Fig. 34)
The router can be guided through the work-
piece in any of several ways. The method
you use depends, of course, on the demands
of the particular job and on convenience.
For routing operations such as grooving or
dadoing, it is often necessary to guide the
tool in a line parallel to a straight edge. One
method of obtaining a straight cut is to se-
curely clamp a board or other straightedge
to the work surface, and guide the edge of
the router sub-base along this path.
Fig. 34
Operation
Using the Palm Router with Fixed
Base (GKF001) and Accessories
Using the Palm Router with Fixed
Base
(Fig. 1, Fig. 35)
1. Install the router bit. See "Installing/Re-
moving a Router Bit" on page 13.
2. Adjust the cutting depth. See "Setting
Depth of Cut" on page 26.
3. Install the Battery Pack 9.
4. Grip the Palm Router 1 firmly using ei-
ther the Palm Router Grip Area 2 or the
Fixed Base Grip Area 15.
Note: In addition to main grip areas, the
Fixed Base has Finger Support Pockets
20 to provide additional stability for the
router. The pockets feature finger guards
to provide a barrier between the finger
pockets and the bit area.
5. Adjust the speed. See "Variable Speed
Dial" on page 29.
6. Switch the Palm Router 1 on. See Fig.
32 on page 29.
Fig. 35
2
edge of
workpiece
20
workpiece
15
20
31
Publicité
