Publicité
Adjusting the Clamping Lever
(Fig. 27)
If additional clamping force is needed, the
Clamping Lever 16 may be tightened.
1. Open the Clamping Lever 16
2. Slightly tighten the nut on the Clamping
Lever 16 using an 8 mm wrench
3. Test the clamping force by installing the
Palm Router 1 into the base then clos-
ing the Clamping Lever 16. If additional
adjusting is needed, repeat steps 1-3
until the Palm Router 1 is secure tightly
in the base.
the tool accidentally, which may result in personal injury.
.
Transportation
Always remove the battery pack before transporting. Carry the tool by
the handles. Such preventive safety measures reduce the risk of starting
Assembly
Fig. 27
.
1
16
25
Publicité
