Laser Emission Data - afx light SCAN1000FX5-RGB Manuel D'utilisation

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

LASER EMISSION DATA

* As measured under IEC measurement conditions for classification.
Laser Classification
Red Laser Medium
Green Laser Medium
Blue Laser Medium
Beam Diameter
Pulse Data
Divergence (each beam)
Divergence (total light)
Cooling
Scanning
Specification:
Mains Input: ....................................................................................... AC100~240V, 50/60Hz, total 30W
Fuse: .................................................................................................... 250V 2A slow blow (20mm glass)
Consumption .................................................................................................................................... 40W
Menu mode: ................................................................... Auto, music, DMX512, Master/slave, ILDA, IRC
Laser power ....................................... Red 200mW 638nm-Green 200mW 532nm-Blue 600mW 445nm
Laser Classification: ..................................................................................................................... Class 3B
Laser Safety Standard: ................................................................................................... EN60825-1:2014
Condition Temperature: .......................................................................................................... 10℃~40℃
DMX channels .............................................................................................. 2 (with ILDA) or 19 channels
Dimensions ................................................................................................................ 290 x 245 x 110mm
Weight: ............................................................................................................................................ 4.5kg
Installation
The unit should be mounted via its screw holes on the bracket. Always ensure that the unit is firmly fixed to avoid
vibration and slipping while operating. Always ensure that the structure to which you are attaching the unit is secure
and able to support a weight of 10 times of the unit's weight. Also always use a safety cable that can hold 12 times
the weight of the unit when installing the fixture.
DMX512
1. Install the units in a suitable position (laying or appending).
2. Use standard XLR microphone cable chain your units together via the XLR connector on the rear of the units. For
longer cable runs we suggest a terminator at the last fixture.
3. Assign a DMX address to each the unit.
4. Turn on all units' power, the units begins reset, then the unit begins working.
5. Use DMX console to control your units.
©Copyright Lotronic 2017
Class 3B
LD GaAlAs 638nm, typical
DPSS Nd:YVO4, 532nm
LD GeAs 445nm, typical
<5mm at aperture
All pulses < 4Hz (>0.25sec)
<2 mrad
<30 degrees
Fan Cooling
ILDA Standard: 25Kpps
3

Publicité

Table des Matières
loading

Table des Matières