Dmx Mode; Slave Mode - afx light SCAN1000FX5-RGB Manuel D'utilisation

DMX MODE

Press FUNC to enter MODE selection

Till to LED panel shows 001

Press ENTER to confirm setting

The laser is working in DMX MODE. With help of UP and DOWN button, the DMX address
could be set.

SLAVE MODE

Press FUNC to enter MODE selection

Till to LED panel shows SLA

Press ENTER to confirm setting

The laser is working in SLAVE MODE. Connect MASTER laser with several SLAVE laser with DMX cable, SLAVE lasers
are doing exactly the same laser show as MASTER laser. Please check chapter for DMX cable connection for referece.
PATTERN MIRROR REVERSE SETTING
Press FUNC to enter MODE selection

Till to below LED display is shown in LED panel and the laser will show pattern right side.

Press ENTER to confirm the setting.

With help of UP button, the laser scanned world in x direction could be reversed, as the graphic as below.

With help of DOWN button, the laser scanned world in y direction could be reversed, as the graphic as below.
Attention: Beside of LED programmed mirror reverse setting, the laser scanned world could be set by

ILDA control panel.
ILDA Control Mode
This unit has the ILDA DB25 port, and it can be controlled by the PC, There is auto transform set in the inside of

the unit to transform the ILDA and preprogrammed show. when connecting with the 25 pin cable, the unit will be
©Copyright Lotronic 2017 6