Fixture Linking; Data Cabling - afx light EVENTBAR-BAT Manuel D'utilisation

Barre de lumiere dmx autonome 4-en-1
Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

spare parts.
• Make sure the power cord is never crimped or damaged.
• Never disconnect the power cord by pulling or tugging on the cord.
• Avoid direct eye exposure to the light source while it is on as sensitive persons may suffer an
epileptic shock (especially meant for epileptics)!.
• The product is for decorative purposes only and not suitable as a household room illumination.
• If the external flexible cable or cord of this luminaire is damaged, it shall be exclusively replaced
by the manufacturer or his service agent or a similar qualified person in order to avoid a hazard.
• If the lenses are visibly damaged by scratches or cracks, stop using the unit immediately and
replace the damaged lenses.
• The light source of this luminaire is not replaceable. When it reaches the end of its life time, the
whole unit must be discarded..
DISCONNECT DEVICE
Where the MAINS plug or an appliance coupler is used as the disconnect device, the disconnect
device shall remain readily operable.
FUSE REPLACEMENT
Locate and remove the unit's power cord. Once the cord has been removed located the fuse holder
located inside the power socket. Insert a flat-head screw driver into the power socket and gently
pry out the fuse holder. Remove the bad fuse and replace with a new one.
Warning: If after replacing the fuse you continue to blow fuses, STOP using the unit. Contact cus-
tomer support for further instructions. Continuing to use the unit may cause serious damage.
INSTALLATION
The unit should be mounted via its screw holes on the bracket. Always ensure that the unit is firmly
fixed to avoid vibration and slipping while operating. Always ensure that the structure to which you
are attaching the unit is secure and is able to support a weight of 10 times of the unit's weight.
Never stand directly below the device when mounting, removing or servicing the fixture.

FIXTURE LINKING

You will need a serial data link to run light shows of one or more fixtures using a DMX-512 control-
ler or to run synchronized shows on two or more fixtures set to a master/slave operating mode.
The combined number of channels required by all fixtures on a serial data link determines the nu-
mber of fixtures that the data link can support.
Important: Fixtures on a serial/data link must be daisy chained in one single line. Maximum re-
commended serial data link distance: 100 meters (1640 ft.)

DATA CABLING

To link fixtures together you must use data cables. If you choose to create
your own cable, please use data-grade cables that can carry a high quality
signal and are less prone to electromagnetic interference.
CABLE CONNECTORS
Cabling must have a male XLR connector on one end and a female XLR
connector on the other end.
DMX connector configuration
Termination reduces signal errors. To avoid signal transmission problems and interference, it is
always advisable to connect a DMX signal terminator.
CAUTION
Do not allow contact between the common and the fixture's chassis ground. Grounding the com-
mon can cause a ground loop, and your fixture may perform erratically. Test cables with an ohm
meter to check correct polarity and to make sure the pins are not grounded or shorted to the shield
or each other.
WWW.AFX-LIGHT.COM
3
EN

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

16-2650

Table des Matières