Dmx Connection; Data Cabling; Display Menu - afx light SPIN12-FX Manuel D'utilisation

DMX CONNECTION

Connect an XLR cable to the male 3-pin XLR output of your controller and the other side to the fe-
male 3-pin XLR input of the light.You can chain multiple lights together through serial linking
The cable needed should be two core, screened cable with XLR input and output connectors.

DATA CABLING

To link fixtures together you must use data cables. If you choose to create your own cable, please
use data-grade cables that can carry a high quality signal and are less prone to electromagnetic
interference.
CABLE CONNECTORS
Cabling must have a male XLR connector on one end and a
female XLR connector on the other end.
Termination reduces signal errors. To avoid signal trans-
mission problems and interference, it is always advisable to
connect a DMX signal terminator.
CAUTION
Do not allow contact between the common and the fixture's
chassis ground. Grounding the common can cause a ground
loop, and your fixture may perform erratically. Test cables with an ohm meter to check correct po-
larity and to make sure the pins are not grounded or shorted to the shield or each other.
NAVIGATION THROUGH THE CONTROL PANEL
Access control panel functions using the four panel buttons located directly underneath the LCD
Display..
Button Function
MENU Used to access the menu or to return to a previous menu option
UP Scrolls through menu options in ascending order
DOWN Scrolls through menu options in descending order
ENTER Used to select and store the current menu or option within a
menu
To access the main menu press the MENU button. Press the UP or DOWN buttons until you reach
function you wish to change. When you reach the function you wish to change, press the ENTER
button. When a function is selected, use the UP or DOWN buttons to change the function settings.
Once your changes are made, press the ENTER button, and then press and hold the MENU button
for at least three seconds to confirm and lock the change into the system memory. To exit without
making any adjustments, press the MENU BUTTON. The display will lock after 30 secondes. Press
the MENU button for 3 seconds to unlock.

DISPLAY MENU

DMX ADDRESS
CHANNEL MODE
SHOW MODE
SOUND SENSE
PAN INVERSE
TILT INVERSE 1
TILT INVERSE 2
TILT INVERSE 3
TILT INVERSE 4
EN 4
A001---A512
15CH, 23CH
DMX, AUTO, SOUND
SOUND SENSITIVITY CONTROL (0-100)
YES, NO
YES, NO
YES, NO
YES, NO
YES, NO
8.8.8.8.
MENU UP DOWN ENTER
© Copyright LOTRONIC 2020