afx light SCAN1000FX5-RGB Manuel D'utilisation page 5

CONTROL & FUNCTION
Regular breaks during operation are essential to maximize the life of this device as it is not designed for continual

use.
Do not switch the unit on and off in short time intervals

Always unplug the unit when it is not used for a longer time. Or before replacing the bulb or start servicing.

In the event of serious operation problems, stop using the fixture and contact your dealer immediately.

Operation：
Mode/Function: Set the operating mode of laser.
Confirmation: Confirms all settings or changes of LED control panel.
UP/DOWN: Changes the operating mode, parameter or DMX address.
Operation:
MODE
STAND ALONE MODE
PREPROGRAM
EFFECT
SOUND
DMX
SLAVE
MIRROR
Attention In preprogrammed standalone SOUND SHOW mode, the laser beam will be blank-out in 10 seconds
without AUDIO/MIC activated signal.
SOUND ACTIVATED MODE sensitivity setting
Press FUNC till to see S 6

 Press UP/DOWN to set microphone sensitivity. S 0 is no sound activated,
from S 1 to S 9, the sensitivity level is going more sensitive.
 Press ENTER to confirm and save the setting.
©Copyright Lotronic 2017
LCD DISPLAY
AUT
A3d
AUB
AUL
AUN
AUO
SUT
S3d
SUB
SUL
SUN
SUO
▐▐▐▐▐▐▐
001
SLAVE
MIRROR
SY:Y SX:Y
DESCRIPTION
Auto Show with Mixed 5 effect
Laser 3D Effect Auto Show
Scanned Beam Effect Auto Show
Laser Lumia Effect Auto Show
Burst Grating Effect Auto Show
Laser Universal Effect Auto Show
Sound Show with Mixed 5 effect
Laser 3D Effect Sound Show
Scanned Beam Effect Sound Show
Laser Lumia Effect Sound Show
Burst Grating Effect Sound Show
Laser Universal Effect Sound Show
Set microphone sensitivity
The laser is working in DMX MODE
The laser is working in SLAVE MODE
The laser scanned world
X/Y
5