Publicité
RECEIVER BOX:
MAINTAINING A WATERTIGHT SEAL
Removing and Installing Radio Gear
The unique design of the receiver box allows the removal and
installation of the receiver without losing the ability to maintain a
watertight seal in the box. The patent-pending wire clamp feature
gives you the ability to also install aftermarket radio systems and
maintain the watertight features of the receiver box.
Removing the Receiver
1. Remove the wire clamp by removing the two 2.5x8mm cap screws.
2. Remove the cover by removing the two 3x10mm cap screws.
3. To remove the receiver from the box, simply lift it out and set to
the side. The antenna wire is still inside the clamp area and cannot
be removed yet.
4. Unplug the servo cables from the receiver and remove
the receiver.
Receiver Installation
1. Install the electronic speed control (ESC), servo,
and antenna wiring through the receiver box
top (A).
2. Plug the ESC and servo wires into the receiver
(see page 14).
3. Bundle wiring as necessary.
4. Make sure the O-ring is properly seated into the
groove in the receiver box bottom so that the
cover will not pinch it or damage it in any way.
5. Place the receiver box top onto the receiver
box bottom and install and tighten the two
3x10mm cap screws securely.
6. Inspect the cover to make sure that the O-ring
seal is not visible.
7. Arrange the wires neatly using the wire guides
on the receiver box top (B). Excess ESC and
servo wiring should be bundled inside the
receiver box. Pull out all available antenna
wiring from the receiver box.
8. Apply a small bead of silicone grease to the foam on the wire
clamp (C).
9. Install the wire clamp and tighten the two 2.5x8mm cap screws
securely (D)..
A
B
C
D
www.modellmarkt24.ch
DRIVING YOUR MODEL
BIGFOOT BRUSHLESS • 23
Publicité
