Publicité
Battery iD
Traxxas recommended
battery packs are equipped
with Traxxas Battery iD. This
exclusive feature allows
Traxxas battery chargers (sold
separately) to automatically
recognize connected battery
packs and optimize the
charge settings for the
battery. This eliminates
the need to worry over
charger settings and menus
for the easiest and safest
charging solution possible.
Visit Traxxas.com to learn
more about this feature and
available Traxxas iD chargers
and batteries.
4 4
14 • BIGFOOT BRUSHLESS
TRAXXAS TQ 2.4GHz RADIO SYSTEM
INSTALLING THE BODY
Your Bigfoot Brushless includes an innovative latching system for
securing the body to the chassis (body clips are not required).
To remove the body for chassis access:
1. Reach beneath the truck body and pull the latches toward the
outside of the truck body to release them from the front and rear
body mounts.
2. Push up on the latches to fully disengage them from the mounts.
3. Lift the body straight up from the chassis. Lift the front and rear of
the body evenly or it may become difficult to remove.
www.modellmarkt24.ch
To reinstall the body:
1. Position the body on the chassis. Align the front and rear of the
body with the bumpers.
2. Press down on the body at each latch location until the latches
snap into place.
Note: To keep the clipless system functioning properly, periodically
inspect and clean the latches in the body and the slots on the
front and rear body mounts. If dirt and grime accumulate on these
components, the clipless system will not operate smoothly.
INSTALLING THE BATTERY PACK
Place the battery pack into
the battery compartment of
the model and then place
the battery hold-down over
the posts. Secure the
battery hold-down with
body clips in the holes in
the posts. Do not connect
the battery pack yet.
Publicité
