Publicité
The Traxxas High-Current Connector
Your model is equipped with the Traxxas High-
Current Connector. Standard connectors restrict
current ow and are not capable of delivering
the power needed to maximize the output of
the electronic speed control. The Traxxas connector's gold-plated
terminals with large contact surfaces ensure positive current ow
with the least amount of resistance. Secure, long-lasting, and easy to
grip, the Traxxas connector is engineered to extract all the power your
battery has to give.
TRAXXAS TQ 2.4GHz RADIO SYSTEM
SETTING UP THE ANTENNA
The receiver antenna and antenna tube
must be properly installed before operating
your model. Follow these steps to install the
antenna and antenna tube:
1. Slide the antenna wire into the antenna
tube to its full extent. When fully inserted,
the wire should reach to approximately
1/2 inch below the tube cap. Do not leave
any slack in the antenna wire.
2. Insert the base of the antenna tube
into the molded post on the chassis.
Take care not to crimp the antenna
wire. Do not bend or kink the antenna
wire! Do not shorten the antenna
tube. See the side bar for more
information
www.modellmarkt24.ch
Antenna
Mount
To prevent loss of radio range,
do not kink or cut the black wire,
do not bend or cut the metal tip,
and do not bend or cut the white
wire at the end of the metal tip.
Correct
BIGFOOT BRUSHLESS • 15
Make certain the model's
receiver antenna is properly
installed before operating
your model. Failure to
properly install the receiver
antenna will result in greatly
reduced radio range and
potential loss of control.
No
No
No
5 5
Publicité
