Publicité
(Safety at work continued)
- The spreader must only be put into service if all the safety devices are ins-
- Before starting spreading, everyone must leave the spreader projection
- Never leave the spreader in operation without surveillance.
- Carrying people on the spreader during transport and use is prohibited.
- Comply with the weight-on-wheels for the front wheels of the towing vehi-
- If there is damage, the spreader must be stopped immediately. Remove
- A non-compliant selection or use of spreading products may cause se-
3.3.Safety when work has finished
- Before leaving the vehicle, the spreader must be placed on the ground,
- If the spreader is uncoupled, the reservoir must be empty and the storage
RS Centrifugal Spreader.................................................................................................................................................... Page
talled correctly. The spreader warning notices must be replaced if they are
missing or illegible.
area. The projected spreading products constitute a hazard!
cle. Behaviour when being driven, as well as turning and braking capacity,
is influenced by the coupled equipment. Therefore ensure there is suffi-
cient vehicle turning and braking capacity. Also comply with the authori-
sed load per axle and total weight of the vehicle. Adapt your driving to
weather conditions and the modified dynamics.
the ignition key from the vehicle and repair the damage before the sprea-
ding equipment is used again. The same goes for damage to the universal
joint.
rious bodily harm as well as harm to animals, plants and the environment.
So read the manufacturer's instructions and those for spreading products
and select the correct product for the intended use.
the engine turned off and the ignition key removed.
surface must be flat and stable.
Safety
42
Publicité
