Publicité
Annexe D
17. Remove the tube holders from the sample tracking
18. Push the tip-tray drawer into the working position.
28. Place the S-Block into the Therm Slot / Adapter (RB).
29. Remove the sample protection shield.
30. Fill all sample tubes of tube holders 1, 6, and 12 with 2
31. Load the other 9 tube holders, loaded with sample tubes,
34. Open the worktable hood.
37. Manually pipet 1000 μl of NaCl (0.9%) into wells A9|H9
38. Place one red tip tray with 1100 μl disposable tips into
40. Attach an empty tip-waste bag.
41. Disconnect the tubing of the system liquid container and
42. Refill the container with deionized water. Close the lid
43. Empty the container. Close the lid and reconnect the
44. Place the 500 ml bottle filled with a minimum of 250 ml
46. Place the system liquid bottle filled with a minimum of
47. Remove any tube holders from the sample tracking
53. Disconnect the tubing of the waste container and remove
57. Press <Continue> to proceed with the protocol.
D-2
system.
ml of NaCl (0.9%), and load them onto the sample
tracking system.
onto the sample tracking system (sample tubes empty or
full).
of a new S-Block. Make sure all other wells are empty!
the red tip-tray holder 4.
remove the lid.
and reconnect the tubing.
tubing.
NaCl (0.9%) into Reagent RotorSlot 2.
600 ml deionized water into RotorSlot 8.
system!
the lid.
BioRobot MDx DSP Manuel d'utilisation 10/2004
Publicité
