LIVARNO home 459479 2401 Instructions De Montage Et Consignes De Sécurité page 6

GB/IE
4. Technical specifications
Type: Washing machine shelving unit
IAN: 459479_2401
Tradix Item No.: 459479-24-A, -B
Model white: 459479-24-A
OR
Model grey: 459479-24-B
Dimensions: approx. 66 x 162 x 30 cm (W x H x D)
Material: Metal powder coated
Production date: 05/2024
Warranty: 3 years
5. Safety information
WARNING!
1
Risk of injury and suffocation!
If children play with the product or
the packaging, they may injure
themselves or suffocate!
- Do not let children play with the product or the
packaging.
- Supervise children who are close to the product.
- Keep the product and the packaging out of the
reach of children.
WARNING!
1
Fatal danger!
Do not drill without checking the
intended positions for electrical, gas
or water lines first! There is a risk of
fatal injuries!
- Damage to electrical, gas or water lines can
cause dangerous situations! Use appropriate
detectors to determine whether hidden lines are
situated in the work area.
WARNING!
1
Risk of injury!
Secure the product against falling
over! There is a risk of injury from jam-
ming!
- It is absolutely necessary to fix the product to a
wall using the supplied cross-head screws
dowels K . The product could, for example, oth-
erwise fall over and injure children.
- Place the product on a level surface.
WARNING!
1
Danger of injury!
A defective product must not be used!
6
There is a risk of injury!
- Do not use the product in the case of malfunc-
tions, damage or defects.
- Significant danger can occur for the user in the
case of improper repairs.
6. Structure
1. Remove all packaging materials.
2. Check whether all parts are available and un-
damaged.
If this is not the case, notify the specified service
address.
3. Place the individual parts as shown in Fig. A.
4. Mount the product as shown in the Fig. B1 to Fig.
D.
- Only tighten the Allen screws
have been assembled.
- Do I not overtighten the Allen screws!
7. Fixing the product to the wall
Risk of injury!
Check the suitability of the wall in advance
to ensure that it is suitable for mounting
the product. There is a risk of injury!
- The supplied cross-head screws
K are not suitable for every wall material, e.g.
plasterboard. In this case, you should obtain the
appropriate screws and plugs from a specialist
store.
The product is intended for use as a superstructure
of a washing machine. Before fixing the product to
the wall behind the washing machine, proceed as
follows:
1. Turn off the washing machine.
2. Disconnect the washing machine from the power
supply.
J and 3. Close the water supply to the washing machine.
4. Pull the washing machine forward away from the
wall.
5. Place the product against the wall at the middle
of the washing machine.
Make sure that the washing machine hoses and pow-
NOTE!
I
WARNING!
1
NOTE!
NOTE!
after all parts
J and dowels