Publicité
1
Innermost glass panel
2
Inner glass panel
3
Outer glass panel
4
Plastic glass panel slot-Lower
As illustrated in figure, raise the innermost glass
panel (1) slightly in direction A and pull it out in
direction B.
Repeat the same procedure to remove the inner
the first step to regroup the door is reinstalling.
inner glass panel (2).
As illustrated in figure, place the chamfered
corner of the glass panel so that it will rest in the
chamfered corner of the plastic slot.
28/EN
Inner glass panel (2) must be installed into the
plastic slot close the innermost glass panel (1).
When installing the innermost glass panel (1),
make sure that the printed side of the panel
faces towards the inner glass panel.
It is important to seat lower corner of inner glass
panel into the lower plastic slot.
Push the plastic part towards the frame until you
hear a "click".
Replacing the oven lamp
ANGER:
efore replacing the oven lamp, make sure
hat the product is disconnected from mains
and cooled down in order to avoid the risk
of an electrical shock.
Hot surfaces may cause burns!
The oven lamp is a special electric light bulb
ithat can resist up to 300 °C. See Technical
specifications, page 11 for details. Oven
lamps can be obtained from Authorised
service Agents.
Position of lamp might vary from the figure.
If your oven is equipped with a round lamp:
1. Disconnect the product from mains.
2. Turn the glass cover counter clockwise to
remove it.
3 de
the oven lamp by aan 00
clockwise and replace it with the new one.
4, Install the glass cover.
Publicité
