Publicité
Product must be installed by a qualified person in
accordance with the regulations in force. The
manufacturer shall not be held responsible for
damages arising from procedures carried out by
unauthorized persons which may also void the
Warranty.
#
Preparation of location and electrical
{installation for the product is under
customer's responsibility.
ANGER:
The product must be installed in
accordance with all local electrical
regulations.
ANGER:
rior to installation, visually check if the
product has any defects on it. If so, do
not have it installed.
Damaged products cause risks for your
Safety.
Before installation
To ensure that critical air gaps are maintained
under the appliance, we recommend that this
appliance is mounted on a solid base and that
the feet do not sink into any carpet or soft
flooring.
The kitchen floor must be able to carry the
weight of the appliance plus the additional weight
of cookware and bakeware and food.
(*) 750 mm
min
e
It can be used with cabinets on either side
but in order to have a minimum distance of
400mm above hotplate level allow a side
clearance of 65mm between the appliance
and any wall, partition or tall cupboard.
e
lt can also be used in a free standing
position. Allow a minimum distance of 750
mm above the hob surface.
e
('fa cooker hood is to be installed above
the cooker, refer to cooker hood
manufacturer' instructions regarding
installation height (min 650 mm),
e
The appliance corresponds to device class 1,
i.e. it may be placed with the rear and one
side to kitchen walls, kitchen furniture or
equipment of any size. The kitchen furniture
or equipment on the other side may only be
of the same size or smaller.
e = Any kitchen furniture next to the appliance
must be heat-resistant (100 °C min.).
Installation and connection
Product can only be installed and connected in
accordance with the statutory installation rules.
Do not install the product next to
refrigerators or freezers. The heat emitted
by the product will increase the energy
consumption of cooling appliances.
e
Carry the product with at least two persons.
e
Product must be placed directly on the floor.
It must not be placed onto a base or a
pedestal.
Do not use the door and/or handle to carry
or move the product. The door, handle or
hinges get damaged.
Electrical connection
Connect the product to a grounded outlet/line
protected by a fuse of suitable capacity as stated
in the "Technical specifications" table. Have the
grounding installation made by a qualified
electrician while using the product with or
without a transformer. Our company shall not be
liable for any damages that will arise due to
using the product without a grounding installation
in accordance with the local regulations.
Publicité
