Publicité
MATAWAY
OVERSEEDER
DISC ALIGNMENT
1. Tip unit forward and place on jack stands. Check
the disc/blade alignment by placing a straight
edge C against the concave side of the either the
fifth or sixth disc A and the corresponding blade
B on the reel. The straight edge should lie flat
against both disc and blade.
Use adequate jack stands when supporting
the unit. Failure to do so may result in
personal injury.
2. The discs can be aligned with the blades by
loosening the two locking collars just inside the
bearings at either end of the disc shaft. Loosen
the set screws and tap the collar clockwise (with
hammer and punch) to unlock, then move the
entire shaft until the discs align with the blades.
Lock the collars against the bearings and tighten
the set screws.
SERVICE
GB-21
Publicité
