Publicité
MATAWAY
OVERSEEDER
TIRE PRESSURE
Keep the tires to the recommended pressure.
Improper inflation will shorten the life of the tires
and cause unsatisfactory operation.
Tires......................................4.10 / 3.50 - 4, 2-ply
Tire Pressure.........24 to 26 PSI (165 to 179 kPa)
CHAIN REPLACEMENT
1. Remove the belt guards and the hopper drive
belt.
2. Loosen the drive chain idler sprocket B.
3. Remove connecting link C and chain D.
4. Install new chain and connecting link.
5. Adjust the idler sprocket to allow approximately 1/
8" (3 mm) to 1/4" (6 mm) of play in the chain
(check for play on the straight section of chain
opposite the sprocket). Tighten the idler sprocket
hardware.
NOTE:
Proper chain tension is essential. A tight
chain will impose excessive bearing loads. A
loose chain will cause noisy operation and chain
pulsations, which may result in irregular sprocket
speed and abnormal chain and sprocket wear.
6. Lubricate the fitting on the idler sprocket.
7. Reinstall the hopper drive belt and make sure all
guards and covers are in place before using the
unit.
Due to low air volume of tires, over-inflation
can be reached in a matter of seconds. To
prevent explosion, check air pressure with
air gauge before filling the tire. Fill to
recommended air pressure, and Do Not
exceed the recommended pressure.
SERVICE
GB-11
Publicité
